Positioning of sensor

The ATOS head is mounted on a tripod or stand and is positioned freehanded in front of the measuring object. There is no need for additional hardware like for example table feed motion setups or robots.

Scanning

The measurement consists of projecting different fringe patterns onto the object's surface using a white light projection unit and capturing these patterns by two integrated cameras at either side of the sensor head. Within seconds, the ATOS software calculates the precise 3D coordinates of up to 4 million object points in each measurement, depending on the sensor type.

Single Measurement

The result of each measurement is directly displayed. The system monitors both its calibration and the influence of environmental conditions by itself, so that reliable, precise and fast measurements can be made, even under rough industrial conditions.

Result

All measurements are automatically transformed into a common object coordinate system. The complete 3D data set can then be exported using standard file formats for an easy postprocessing.